Hello,
A while ago I was able to have both of my monitors detected and working using windows 7 through WMware Fusion3.
There were still some issues, but it worked:
- I had to 'reset' (change back and forth) the screen resolutions in windows for the resolutions to display properly after each windows load, but at least it worked after I did it.
Even though on my MAC, the 2nd monitor always worked,while I had VMware 3, for some reason after months, it stopped detecting my 2nd monitor withing the Windows 7 VM.
It still detected a monitor in the windows display settings but when I clicked on identify monitors, it wouldn't affect the 2nd monitor (I would only see part of my mac desktop).
I then removed the 2nd monitor from windows 7 but it won't re-detect it.
I upgraded to VMWARE 4 and upgraded my mac to 10.7.2 hoping this would refresh and fix this error, but I'm still having the same problems:
The 2nd monitor only shows my mac desktop and is not detected by windows 7.
I've attached collected support information (.tgz file). Any ideas as to any next steps I should try?