Hi,
i have a setup with two vcenter sites and the new vmware replication appliance on every site.
i have connected the two sites with an vpn tunnel and both replication appliances are connected.
until this, everything works fine.
my problem is when i want to setup an replication job from a VM in SITE1, in the wizard i can't select the target-datastore on SITE2.
so i cant go to the next steps in the wizard and i cant finish the replication job.
when i do the same thing in the other direction (a VM from SITE2 to SITE1) i can select my 2 datastores in SITE1 and everything is working fine.
what could be the problem?
is there any limitation for the datastores?
i cound see noone of my datastores on SITE2, even not the local datastore disk.
i saw one point when i look at the datastores on both sites:
on site 2 (where i cant select the datastores) all datastores are marked as "hardwareaccelerator = true"
on site 1 (where i can select the datastores) my datastores are marked as "hardwareaccelerator = unknown"
cound that be the problem?
how can i turn off the hardware-accelerator for testing this?
thanks for every help!
best regards,
bernd
